Freud LU91M012 12-Inch, Wonderful replacement for..

Overall Rating44444

Wonderful replacement for standard blade

I use this blade on a Dewalt 709 Compound Sliding Miter Saw. I purchased it based on reviews on other woodworking sites and while there were others rated higher, it was hard to justify the dramatic increased price of the Forest or even other Freud blade. I have had a Freud 10″ combination blade in my tablesaw and have used a Freud 8″ stack dado set for about 10 years and have had absolutely nothing but good experiences with both. This 12″ cutoff blade is such a treat, especially after wearing out the original DeWalt blade on a deck, a complete refinish of a basement and installing hardwood flooring on one floor of a house. I thought about just getting the blade sharpened but there was almost nothing left to sharpen. The Freud blade is so quiet and cuts so smoothly that there have been times I’ve had to check to see if I really did shave a little off the board or missed completely. Heartily recommend this blade for CSMS users.

Update (2/9/2012):

The featured review for this product, Freud LU91M012 12-Inch 72 Tooth ATB Thin Kerf Sliding Miter Saw Blade with 1-Inch Arbor Tools & Hardware, was written by D. Oppenheimer.

The average rating for this item is 2 out of 5 stars, according to 2 reviews.

Related posts:

  1. Freud LU96R010 10-Inch, Like a hot knife through..
  2. Freud TK906 Avanti, Great blade - great price
  3. Freud D0620X Diablo, Good blade
  4. Freud LU85R010 10-Inch, as smooth as glass
  5. Freud LU82M010 10-Inch, Great Blade - Great Price

Reviews (2)

D. Oppenheimer

May 9th, 2010 at 9:18 pm    


Overall Rating44444

Wonderful replacement for standard blade
Rated 4 stars.


Unknown

May 26th, 2010 at 10:29 am    


Overall RatingNot Rated

Product Description
This thin kerf industrial blade provides a high-quality finish with sliding miter saws saws.5 degree negative rake angle cut to prevent, remove the blade from fence.kerf as too aggressive and pushes the work piece down and towards the blades less material than conventional carbide blades, require less horsepower, thus leading to equally good results. Application: fine-tuning for Blades & Mitre Saws Radial Arm


Leave a reply

Overall Rating

Name *

Mail *

Website